Plastic fine mist sprayer, 24/410, black, shiny gold collar

Plastic pump sprayer 24/410 turns any bottle with the same neck finish into a ready-to-use spray. It is a mechanical sprayer with a black head and a glossy gold aluminium collar that gives the packaging a dark, uniform look and pairs well with black, brown and clear bottles. It is designed for cosmetic products and is particularly suited to facial toners, hydrolats, hair sprays and refreshing waters — that is, thin liquids that need to be applied evenly and without direct hand contact.

Key features

• Hygienic dispensing – the contents are released only when the head is pressed; no fingers go into the bottle and nothing spills out. With water-based contents this reduces the risk of contamination.
• Small, repeatable dose – each press delivers approximately 0.12 ml, making it easier to apply the right amount to skin or hair while reducing waste.
• Plastic and aluminium construction – the body and mechanism are made of PP plastic; the collar is aluminium with a glossy gold finish. The sprayer is lightweight and does not add noticeable weight to the packaging.
• Cosmetic and technical-grade quality – in addition to cosmetics, it is also suitable for working solutions in a workshop, for example ethanol for mould disinfection or water for humidifying during soap production.

Use and bottle selection

The sprayer fits any bottle with a 24/410 neck finish. The thread size is listed in the parameters of each bottle; compatible bottles and ready-made bottle-and-sprayer combinations are available in the Handymade range. For your own combination, we recommend checking the seal and the sprayer's behaviour with the specific formulation, especially if the bottle comes from a different supplier.

It works best with thin, aqueous or mildly alcoholic liquids: toners, hydrolats, floral waters, water- and alcohol-based spray deodorants, hair waters, air fresheners and fabric sprays. Thick serums, oils, emulsions and contents with particles (scrubs, undissolved powders) cannot be dispensed through a mechanical sprayer. They clog the nozzle or flow in a stream rather than producing a fine mist.

When filling, leave some headspace below the neck. A bottle has a nominal volume it is designed for and a larger total capacity up to the brim. Once the sprayer is screwed on, the dip tube and valve take up part of that space, and a bottle filled to the brim would push contents out through the neck when the cap is tightened. Always fill to the nominal volume, not to the brim.

Good to know

• Preparation before first use – rinse the sprayer with clean water or spray it several times with ethanol and allow to dry thoroughly. Only then attach it to the filled bottle.
• First pumps – while the tube and valve are filling, the head needs to be pressed several times without dispensing anything. It helps customers if you note this on the label or in the instructions.
• Essential oils and solvents – plastic parts and seals may change properties over time when in contact with a high proportion of essential oils, concentrated fragrance, or strong solvents. With such contents, carry out a test on a single unit.
• Reuse – the sprayer cannot be disassembled; once the bottle is empty, simply rinse it with warm water and ethanol and allow to dry. Dried residue, particularly from contents containing glycerin or extracts, will clog the nozzle and the spray pattern will become uneven.
• Storage of unused units – keep in a dry and clean environment, in a sealed bag or box, to prevent dust from getting into the mechanism.
• Recycling – the sprayer combines plastic with an aluminium ring and therefore cannot be sorted as pure plastic. Disposal method depends on the local collection system.

Frequently asked questions