Shiny Silver Push Dropper, 20/410, 64 mm

Silver glossy push dropper 20/410 – precise dosing for serums and oils

Push dropper is a closure with a press button for bottles with a neck type 20/410. It replaces a regular cap and turns the bottle into a dispensing container: pressing the button draws the contents into the glass tube and then releases them drop by drop exactly where needed. The glossy silver finish looks neutral and suits both clear and coloured glass.

It is particularly suitable for facial serums, facial and body oils, blends of essential oils in carrier oil, tinctures and concentrated active ingredients. For these products, a small amount is dispensed and it matters that the contents are not spilled or contaminated by fingers. The packaging is suitable for contact with cosmetic products.

Key features

• Glass tube – glass does not react with oils, essential oils or alcoholic solutions, does not absorb scent and does not stain. The dropper is therefore suitable for concentrated and aromatic contents.
• Button dispensing – the contents are drawn up and released by pressing the top button. You can measure a small amount drop by drop without spilling and without hand contact with the contents.
• Hygienic use – unused remainder returns to the bottle, reducing the risk of contamination of leave-on products with active ingredients.
• Uniform appearance – the silver glossy surface combines with brown, blue, frosted and clear glass.

Which bottles the dropper fits

The dropper fits bottles with neck type 20/410. This information can be found in the parameters of each bottle. The second decisive dimension is the dropper length, which is directly in the product name. The tube should reach close to the bottom of the bottle so that the last remaining contents can be drawn up, but should not rest against the bottom. With a significantly taller bottle, an inaccessible remainder will be left at the bottom; with a shorter one, the dropper cannot be tightened properly.

Bottles with the same neck type and ready-made bottle + dropper combinations are available in the Handymade range. For a custom combination, we recommend verifying the seal, dosing and packaging behaviour with the specific formulation before filling a larger batch.

Suitable for products such as

• Facial serums on a water and oil base, where a few drops are dispensed per application.
• Facial and body oils and beard oils including blends with essential oils, where you will appreciate glass with no residual scent.
• Tinctures and alcoholic extracts, where the glass tube withstands alcohol without any change in appearance.
• Concentrates of active ingredients, such as solutions to be added to a cream or mask, where the exact number of drops matters.

The dropper is less suitable for thick creams, high-viscosity gels and products with insoluble particles. These are drawn up through the tube with difficulty or clog it. For such textures, a jar or pot is more appropriate.

What to know when working with the dropper

Before first filling, we recommend disassembling the dropper into accessible parts, washing it, disinfecting with isopropyl alcohol or ethanol and allowing to dry completely. Moisture in the tube would get into the anhydrous oil or serum and could affect its stability.

The glass tube is fragile. When tightening the dropper, do not press the tube against the bottom of the bottle, and inspect it after dropping it on a hard surface. A cracked tube must not be used further.

For products with a high content of essential oils, solvents or with a low or high pH, we recommend verifying how the seal and button behave before batch filling. Glass itself tolerates these substances; the behaviour of the other parts depends on the specific formulation.

The dropper can be reused after thorough washing and disinfection, ideally for the same type of product. When disposing, the glass tube is sorted as glass and the other parts by material. As this is a composite packaging, it is appropriate to separate the parts before disposal.

Frequently asked questions