Plastic bottle, clear round, white ribbed pump, 750 ml

750 ml plastic bottle with pump is a complete packaging solution for liquid cosmetic products used daily and in larger amounts: liquid soaps, shower gels, shampoos, conditioners and body lotions. It consists of a clear round-shaped bottle and a white pump with a ribbed collar. The pump allows dispensing the contents with one hand without opening the bottle, minimising contact between the product, water and hands.

The clear plastic shows the colour of the product and how much remains in the bottle. The bottle is lightweight and will not shatter if dropped, making it suitable for the bathroom, shower or washbasin where glass would be a hazard. However, the transparent material does not protect the contents from light, which should be taken into account with more sensitive formulations.

What the set is suitable for

• Liquid soaps and shower gels – a larger volume lasts longer at the washbasin or in the shower and does not need to be refilled as often.
• Shampoos and conditioners – the pump dispenses even with wet hands; no need to lift or open the bottle.
• Body lotions and lighter emulsions – contents are dispensed without reaching into the bottle with fingers.
• Refill and family-size packs – practical for salons, workshops and facilities with higher consumption.

The pump works reliably with liquid to medium-viscosity products. Very thick creams, butters and products with solid particles (scrubs with salt, sugar or crushed kernels) do not pass through it evenly and may clog it.

How the pump dispenses

One full press delivers approximately 1 ml of product. On first use, the pump needs to be pressed several times without dispensing until the tube fills. The ribbed collar makes it easier to grip when screwing on and tightening, even with wet hands.

Nominal and total volume

The 750 ml figure is the nominal volume, meaning the amount for which the bottle is intended under normal filling conditions. The total volume to the top of the neck is slightly larger. The difference serves as a reserve for the pump mechanism and tube, which displace some of the contents when fitted, and for product expansion with temperature changes. The bottle should therefore be filled to the nominal volume, not to the brim.

What to know before filling

Before first use, wash the bottle with warm water and soap, rinse, disinfect with isopropyl alcohol or ethanol and let it dry completely. Rinse the pump by pumping warm water through it, then the disinfectant; it must also dry completely before fitting. Any moisture left inside unnecessarily strains the product’s preservation.

Plastic does not tolerate high temperatures as well as glass. Allow the contents to cool to room temperature before filling and do not boil the bottle. For formulations with a high proportion of essential oils, alcohol or solvents, we recommend verifying compatibility with the packaging by testing on a small quantity.

Both the bottle and the pump are declared as suitable for contact with cosmetic products.

Closures with the same neck type and other ready-made combinations are available in the Handymade range. For custom combinations, we recommend verifying the seal, dispensing behaviour and container performance with the specific formulation. Empty rinsed bottles belong in plastic recycling.

Frequently asked questions