High Clear Plastic Bottle, Black Pump with Smoky Overcap, 100 ml

Yes, the packaging can be used repeatedly if proper care is taken and hygiene principles are observed. Before each new filling, the bottle and the dispenser must be thoroughly cleaned and then disinfected, for example using isopropyl alcohol IPA 99 % or vegetable ethanol Ethanol 96 % denatured. After disinfection, allow all parts to dry completely at room temperature. As this is PET packaging, avoid high temperatures, do not boil it and do not wash it in a dishwasher, so that the material is not deformed and the functionality of the dispenser is not impaired.

First disassemble the packaging – separate the bottle, the pump and the cap. Rinse out the residues of the original product with lukewarm water and a mild detergent and rinse thoroughly with clean water. We then recommend disinfection with a suitable alcohol solution, for example IPA 99 % or Ethanol 96 % denatured vegetable. Do not expose the PET material to high temperatures – do not boil the bottle and do not put it in a dishwasher, so that the material is not deformed or weakened. After disinfection, allow all parts to air dry in a clean place.

If you decide not to use the bottle and the dispenser further, it is recommended first to empty them and, where possible, remove as much product residue as possible. Then proceed according to the recycling recommendations given in the parameter table for the product on the Handymade.sk website, where you will find information about the specific type of plastic and the recommended sorting. In most cases, plastic packaging is sorted into the appropriate container for plastics, and for combined packaging (for example, different material of the body and the pump) it may be necessary to separate the individual parts. By following the recommended procedure, you will contribute to proper waste processing and to reducing environmental burden.

It is not recommended to fill PET packaging with hot or freshly cooked products, because high temperature can lead to deformation of the bottle, deterioration of the sealing or changes in the properties of the material. Products should be poured only after they have cooled down to room temperature. This also reduces the risk of steam condensation inside the packaging and contributes to better stability of your formulation during storage and use.

To make it easier to choose the right packaging, you can use the advanced filter, which is available at the top of the page after clicking on the relevant packaging material category. With the help of the filter, you can quickly narrow down the offer according to key parameters such as type and neck diameter, size, colour or material used. We recommend first determining what type of product you will be packaging (e.g. liquid, gel, oil-based), and then selecting in the advanced filter the combination of parameters that best matches your requirements for design, functionality and dosing method.