Plastic bottle, amber, matte black mini trigger sprayer, smooth collar, 100 ml

The amber plastic bottle with a mini trigger sprayer is a set for spraying thin, water-based cosmetic products, most often toners, hydrosols and refreshing sprays for the skin or hair. The amber tint of the PET bottle filters light, so hydrosols or toners with plant extracts, which are sensitive to light, keep their colour and fragrance for longer. The 100 ml bottle fits in a handbag as well as in a travel bag. PET is lightweight and does not shatter.

The matte black sprayer with a smooth collar gives the packaging a uniform look that matches the amber bottle. Both the sprayer and the bottle have a 24/410 neck finish, and the set includes both parts.

What it is suitable for

• Facial toners and hydrosols – the sprayer disperses the liquid into a fine mist that is applied to the skin without cotton pads.
• Hair sprays – thin hair tonics, scalp solutions or protein sprays that make combing easier.
• Refreshing and body sprays – water-based sprays with solubilised essential oils, applied in a thin layer.

The mini trigger sprayer is designed for a liquid as thin as water. A different type of closure is suitable for oils and products thickened with gelling agents.

Volume and filling

The nominal volume of 100 ml is the volume the bottle is designed for under normal filling. The brimful capacity listed in the parameters is the physical volume of the bottle up to the neck. The difference between them is a reserve for the sprayer tube, for the air above the liquid and for the expansion of the contents when the temperature changes. Therefore, fill the bottle to the nominal volume, not to the brim. An overfilled bottle overflows through the neck when the sprayer is screwed on, and the contents get into the thread.

One press of the sprayer dispenses approximately 0.35 ml, which for a full pack corresponds to hundreds of doses. When calculating the usage rate of active ingredients in a toner, count this amount as one application.

Good to know

Before the first filling, rinse the bottle and the sprayer with clean water, disinfect them with isopropyl alcohol or ethanol and leave them to dry completely. The sprayer is disinfected by spraying the disinfectant solution through it several times, followed by clean water.

Fill the bottle only after the contents have cooled down. The PET bottle is not designed for hot liquids, and at a higher temperature it may deform and the neck will then not seal. For the same reason, do not store the finished product in the sun or near a heat source.

The set is declared as suitable for contact with cosmetic products, and the declaration of conformity and technical documentation are provided with the product. It is not approved for contact with food.

If you want to replace the sprayer with another closure, in the Handymade range you will find caps, pumps and other sprayers with the same neck type, as well as ready-made combinations. With your own combination, we recommend testing the seal and dispensing with your specific formulation.

The bottle is made of PET and the sprayer of PP. Before recycling, unscrew both parts and sort them separately.

Frequently asked questions