Amber Round Sirup Glass Bottle, 28 mm, White Pump, 300 ml

This amber glass medicine bottle with a white pump holds 300 ml and dispenses liquid to moderately thick cosmetic products straight from the bottle, with no unscrewing and no fingers touching the contents. The dark glass blocks much of the light that speeds up the oxidation of oils and the fading of sensitive ingredients, so the set suits body lotions, liquid soaps, washing gels, make-up remover oils and massage oils that should not sit on a shelf in clear packaging.

The set as a whole is declared suitable for contact with cosmetics; you will find the declaration of conformity with the product.

What the set is suitable for

• Body lotions and lighter creams – the pump delivers the same dose with every press, the contents do not spill, and neither fingers nor skin residue get into the bottle.
• Liquid soaps and washing gels – the 300 ml volume matches a standard dispenser at the sink or in the shower.
• Massage, body and make-up remover oils – light-sensitive oils last longer in dark glass without any change in scent, and the pump dispenses them without dripping down the walls of the bottle.
• Micellar waters and liquid facial cleansers – you can apply water-based formulations to a cotton pad with the pump without opening the bottle, so the contents are less exposed to air.
• Shampoos and liquid conditioners – anything with a consistency the pump is able to draw up.

Dispensing and volume

One press of the pump delivers a dose of approximately 1 ml. With a body lotion or liquid soap, the customer therefore measures out the amount for a single use, and you can estimate how many applications a bottle will last.

The nominal volume of 300 ml is the amount the bottle is designed to hold under normal filling. The brimful capacity given in the parameters is the physical volume up to the neck. The difference leaves room for the pump tube, the air above the liquid and the expansion of the contents when the temperature changes. The bottle should therefore be filled to the nominal volume, not to the brim. If it is overfilled, the contents are pushed out through the neck when the pump is screwed on.

Good to know

Before the first filling, wash the bottle, disinfect it with isopropyl alcohol or ethanol and let it dry completely. Rinse the pump with clean water, press it several times without any liquid and let it dry as well, so that no water is left in the tube to dilute the first dose.

Glass does not tolerate sudden temperature changes well. Let the emulsion or soap cool to approximately room temperature before filling, and do not fill a cold bottle with hot contents.

The pump is made of plastic and is designed for liquid and moderately thick products. It draws up thick creams, body butters or products with scrub particles only with difficulty, and particles may clog it. For formulations with a high proportion of essential oils, alcohol or other solvents, we recommend checking how the plastic parts behave during longer contact, especially their tightness and any change in appearance.

Other closures with the same thread type also fit the neck of the bottle; you will find ready-made combinations in the Handymade range. If you make your own combination, we recommend checking the tightness, the dispensing and the behaviour of the packaging with your specific formulation.

After thorough washing and disinfection, the glass bottle can be reused. Before reuse, rinse the pump with warm water, pump it several times and let it dry. If it stays sticky or leaks, replace it. For recycling, separate the two parts: the glass goes with glass and the pump with plastics.

Frequently asked questions