Yes, the bottle with dispenser is suitable for packaging various liquid cosmetic products such as toners, light emulsions, body and face lotions or oil blends intended for external use. When planning its use, we always recommend testing the compatibility of the specific formulation with the packaging – especially in the case of a high proportion of essential oils or active ingredients – in order to verify proper sealing, dosing and stability of the contents over time.

The packaging can be reused provided that basic hygiene rules are observed and the packaging is not visibly damaged. Before each new filling, the bottle and the dispenser must be thoroughly cleaned and disinfected, ideally using a suitable alcohol such as isopropyl alcohol or plant ethanol. After applying the disinfectant, allow all parts to dry completely so that moisture does not accumulate in the packaging. When switching to another type of product (for example from oil-based to water-based), we recommend using the packaging only if you are sure that no residues of the original product or odour remain.

The dispenser should be cleaned gently so that the delicate parts of the pump are not mechanically damaged. After the contents have been used up, rinse the inside of the system with warm (not boiling) water, optionally with a mild non-aggressive cleaning agent, and then pump clean water through the mechanism several times. Then apply a suitable disinfecting alcohol and pump the dispenser again so that the disinfectant reaches the entire system. Finally, allow the individual parts to dry freely at room temperature and store the dispenser assembled only after it has completely dried.

Before recycling, it is advisable to empty the packaging thoroughly and remove any product residues. The method of sorting is determined by the material specified in the product parameters – on this basis you assign the packaging to the appropriate recycling stream (for example, plastic packaging to the container intended for plastics). If the bottle is made of several materials, it is recommended, where possible, to separate the individual parts (bottle body, dispenser) and sort them separately. Information on the specific material composition can be found in the product parameter table on the packaging page, on the basis of which the correct recycling procedure can be chosen.

When choosing suitable packaging, you can use the advanced filter available at the top of the page after clicking on the relevant packaging material category. In the advanced filter you can easily narrow down the offer according to key parameters such as neck type, size, colour or packaging material. In this way you can choose a bottle, dropper bottle or jar that best matches the consistency of your product, the intended dispensing method and the visual style of your brand.