The packaging can be used repeatedly if basic hygiene principles are observed and a suitably chosen type of filling is used. Before each new filling, the bottle and the dropper closure must be thoroughly cleaned and then disinfected, ideally using a suitable alcohol, for example IPA 99% isopropyl alcohol or ethanol 96% denatured, plant-based. Only after completely drying is the packaging ready for further safe use.

Before further use, we recommend first rinsing the bottle and the inner dropper insert with a suitable cleaning solution or warm water with a mild surfactant, then rinsing thoroughly with clean water and allowing it to drain. After mechanical cleaning, the packaging must be disinfected – most commonly an alcohol based on isopropanol or ethanol is used, for example products available on Handymade. After disinfection, allow all parts to dry completely on a clean surface to prevent dilution or contamination of the next filling.

If you decide not to reuse the packaging, we recommend recycling it to the maximum possible extent. Proceed according to the material type stated in the product parameter table – an indicative marking can also be found on the bottom or side of the bottle. Before handing it over for separate collection, it is advisable to use up the contents thoroughly, rinse out any residues as much as possible and disassemble the individual parts of the packaging (bottle, dropper, possibly cap) if they are made of different plastics. Then place them in the appropriate container according to local waste separation rules so that the material can be reprocessed in the recycling process.

The dropper closure is designed primarily for thin, low-viscosity liquids for which it is necessary to control the number of drops or very small doses of the product. These include, for example, aqueous solutions of active substances, toners, certain extracts or technical solutions. Thicker emulsions or oil blends may drip more slowly or unevenly, so for atypical formulations it is important to carry out your own dosing test and, if necessary, choose a different type of closure or packaging.

The fastest way to select is to use the advanced filter in the packaging category. After clicking on the relevant category (for example bottles, dropper bottles or cosmetic packaging), you will find the advanced filter at the top of the page. Using it, you can sort packaging according to several parameters – most often by neck type, size, colour and material. Thanks to the combination of filters, you will select only those packages that meet the technical and design requirements of your specific product.