The packaging can be reused if basic hygiene rules are observed and it is handled appropriately. Before each new filling, it is necessary to thoroughly clean the bottle and the dispenser and then disinfect them, ideally using alcohol-based preparations such as isopropyl alcohol or ethanol. For this purpose, you can use the products IPA 99% isopropyl alcohol or Ethanol 96% denatured plant-based. After complete drying and airing of the disinfectant, the bottle can be refilled with a suitable preparation.

The plastic packaging is not intended to be exposed to high temperatures. With long-term or intense heat exposure, there is a risk of softening or deformation of the material, which may negatively affect the sealing and function of the dispenser. The packaging is not suitable for cleaning in a dishwasher or for boiling. For cleaning, we recommend hand washing with lukewarm water and a mild detergent, thorough rinsing and subsequent disinfection with a suitable alcohol-based preparation before the next filling.

Before filling, make sure that the bottle and all parts of the dispenser are clean, disinfected and completely dry. Fill slowly, ideally using a funnel or dosing syringe, leaving a slight headspace below the thread so that overflow does not occur when the dispenser is fitted. Screw the dispenser on evenly without excessive tightening so that the seal is not compromised. We then recommend checking, by pressing several times, that the pump dispenses evenly and without excessive air intake.

To make selecting the packaging easier, you can use the advanced filter available at the top of the page after clicking on the relevant packaging material category. Using the filter, you can quickly narrow down the range according to specific parameters such as neck type and size, packaging size, colour or material used. By combining these options, you will find a bottle, pharmaceutical bottle or other packaging that best suits the nature of your product and the desired method of application.

If you decide not to use the packaging any further, we recommend that, after the contents have been used up, you empty it as thoroughly as possible and clean it. The method of recycling is determined by the type of plastic indicated in the product parameters and the corresponding recycling symbol. On the basis of this information, place the bottle and the dispenser in the correct separated waste stream according to the system in your municipality. By following the recommended material-based sorting given in the product parameters, you will contribute to the efficient processing and reuse of raw materials.

The bottle with dispenser is ideal for low- to medium-viscosity preparations where precise and hygienic dosing is desirable – for example, facial serums, emulsion fluids, light body milks, hair tonics or special treatments for local application. For thicker balms or very thin, highly volatile formulations, we always recommend first carrying out a trial filling and monitoring the behaviour of the product over time to verify the smooth operation of the pump as well as the stability of the contents.