The packaging can be reused as long as the functionality of the sprayer is maintained, if you strictly follow hygiene rules. Before each new filling, the bottle and the sprayer must be mechanically cleaned and then disinfected with a suitable alcohol-based preparation, for example using the products IPA 99 % – isopropyl alcohol or ethanol 96 % denatured vegetable. After disinfection, allow all parts to dry thoroughly at room temperature and only then refill them. In case of damage, significant wear or reduced functionality of the mechanism, we recommend removing the packaging from use and recycling it.

If you decide not to reuse the packaging, we recommend that after emptying and basic rinsing you recycle it according to the material listed in the product parameters. The bottle and the sprayer are made of plastic that is normally sorted into the appropriate container for plastic waste. Before placing it in the sorting system, it is advisable to remove any product residues from the packaging, but it is not necessary to remove a possible label unless this is required by local waste sorting rules. Always follow the local collection system and the recommendations of your municipality or collection company.

The sprayer is designed for the application of low-viscosity liquids, that is mainly water-based and alcohol-based solutions without large undissolved particles. It is suitable for facial and body waters, hair sprays, air fresheners, aromatic mist blends and mild cleaning solutions. Thick emulsions, gels or blends with a significant proportion of undissolved particles can clog the mechanism or reduce the quality of spraying, and therefore other types of dispensers (for example pumps) are recommended for them.

Before repeated filling, it is advisable first to rinse the bottle and sprayer with warm water and a mild cleaning agent, remove mechanical impurities and residues of the original product. Then we recommend rinsing with clean water, letting it drain and disinfecting with a suitable alcohol – the products IPA 99 % – isopropyl alcohol or ethanol 96 % denatured vegetable are practical. You can also draw the disinfectant solution into the sprayer and spray it several times so that the inner capillary is cleaned. After disinfection, it is important to let all parts dry completely at room temperature and only then refill them with a new product.

To select a suitable bottle, jar or dispenser, you can use the advanced filter, which appears at the top of the page after clicking on a specific packaging category. In the advanced filter it is possible to combine several parameters at the same time – in particular the type of neck, size, colour and material of the packaging. Thanks to this, you can quickly filter only those bottles, jars and closures that correspond to your product and to your requirements for design, volume and dosing method.