Yes, the bottle can be used repeatedly if hygiene rules are observed. However, before each new filling, it is necessary to clean and disinfect the packaging thoroughly to avoid microbial contamination or undesirable reactions with residues of the original product. For disinfection, we recommend using highly concentrated alcohol, for example IPA 99% isopropyl alcohol or Ethanol 96% denatured plant-based, which are suitable for treating a clean and dry packaging before new filling.

The glass part of the dropper can be carefully rinsed with a suitable cleaning agent, then thoroughly rinsed with clean water and left to dry completely. The rubber and plastic part must be cleaned gently, without using aggressive solvents and high temperatures, in order to prevent deformation or changes in the material properties. After cleaning, it is advisable to disinfect the internal surfaces with alcohol and let them dry completely before reuse.

The bottle with dropper is ideal for liquid products with low to medium viscosity that need to be dosed drop by drop or in a small, precisely controlled amount. It is excellent for facial and body oils, concentrated serums, active solutions, booster drops, aromatherapeutic blends or trial laboratory solutions. For thicker emulsions or gels, we recommend performing a dosing test before using it in final production, in order to verify the suitability of the dropper for the specific formulation.

If you decide not to use the packaging further, we recommend recycling it according to the material types listed in the product parameters. After emptying and basic rinsing, place the glass bottle into sorted glass waste according to local collection rules. The dropper consists of several components (glass, plastic, rubber part), therefore it is advisable to separate them where possible and sort them according to material, or, if the local sorting system does not allow detailed sorting of these types of packaging, to hand them over to a collection yard. Always follow the recommendations in the parameter table and the local waste sorting rules.

The simplest solution is to use the extended filter in the packaging category. After clicking on the relevant category (for example bottles, jars or pots), you will find the extended filter at the top of the page. With its help, you can narrow down the selection according to several parameters – especially according to the neck type, size, colour and packaging material. In this way you can quickly find the combination of bottle and closure that best matches your product and the technical requirements for packaging.

We recommend storing filled bottles in a dry and cooler place, away from direct sunlight and sources of heat. After each use, it is important to close the dropper tightly in order to minimize contact with air and impurities. For sensitive formulations, such as products with a high content of natural oils or active substances, proper storage can significantly affect the stability, fragrance and consistency of the product. Always also follow the recommendations of the manufacturer of the cosmetic or other filling that you are placing in the packaging.