The packaging can be used repeatedly if handled correctly and if hygiene principles are observed. Before each new filling it is necessary to clean the bottle thoroughly and disinfect it in order to minimise the risk of microbial contamination of the product. For disinfection, we recommend using a suitable alcohol-based preparation, for example isopropyl alcohol or ethanol intended for this purpose, available in the Handymade range. After disinfection, allow the packaging to dry completely and only then refill it.

Before repeated use, we recommend first rinsing the bottle with a residual compatible medium (for example a suitable oil or distilled water according to the type of the original content), then washing it with a mild non-aggressive cleaning agent and rinsing thoroughly. After washing, the packaging must be disinfected using a suitable alcohol and left to dry completely. When cleaning, avoid very hot water and aggressive chemicals that could shorten the service life of the plastic or affect its appearance.

If you decide not to reuse the packaging, we recommend recycling it in accordance with local waste-sorting rules and with the information given in the parameters of the specific product on the Handymade website. Before handing it over for recycling, remove any residue of contents and labels and, if possible, rinse the packaging. Then place it in the appropriate container according to the plastic type specified in the parameter table. By following these steps, you will contribute to more efficient material processing and a reduction in the amount of waste.

When filling thicker or oily formulations, it is advisable first to test the behaviour of the product in a small trial quantity. Observe whether the material of the closure and the bottle seals well, whether there is any seepage and whether dosing is practical in normal use. It is also recommended not to exceed the maximum filling level so that there is space for closing the closure without forcing out the contents. In the case of a high proportion of oils or solvents, always carry out a compatibility test over a shorter time period in order to identify any changes to the packaging in good time.

To select suitable packaging, you can use the extended filter, which is available at the top of the page after clicking on the relevant packaging category. In the extended filter, products can be sorted according to several parameters, such as neck type, size, colour or packaging material. This allows you to quickly narrow down the selection to packaging that meets your requirements for design, functionality and compatibility with existing closures or dispensing systems. In case of any doubts, we recommend comparing several types of packaging and also considering the characteristics of the specific product you plan to fill.