Yes, the packaging can be used repeatedly for cosmetic formulations, provided that you observe basic hygiene rules. Before each new filling, the bottle and the dispenser must be thoroughly cleaned and then disinfected with a suitable alcohol-based product, for example with isopropyl alcohol or ethanol of plant origin. Disinfection should be carried out at room temperature and with an adequate contact time, in order to ensure the highest possible level of cleanliness without thermal stress on the plastic.

First, rinse the packaging mechanically with the remaining amount of a suitable cleaning solution or with lukewarm water (not hot, to avoid deformation of the plastic). Then apply disinfection – it is recommended to rinse or spray the inner walls and the dosing mechanism with products such as IPA 99 % or 96 % plant-based ethanol. After disinfection, allow the packaging to air out freely and dry completely, and only then proceed to filling with the new formulation.

The construction of the dispenser is primarily adapted to liquid and lightly gel-type products, such as emulsions, light body milks, gels or serums. For very thick creams, dosing may be limited or uncomfortable. It is therefore recommended to carry out a trial filling before final bottling to verify whether the viscosity of your product corresponds to the capabilities of the particular dispenser and allows smooth application without excessive pressure.

To choose suitable packaging, you can use the extended filter, which you can find at the top of the page after clicking on the relevant packaging category. In the filter, you can clearly set parameters such as neck type, packaging size, colour and material, as well as other properties depending on the category. In this way, you can quickly filter only those bottles, jars or vials that meet the requirements of your product and your filling technology.

If you decide not to reuse the bottle with dispenser, it is recommended to recycle it according to the type of plastic indicated in the parameter table for the product. First remove any remaining product, rinse the packaging if possible and then sort it into the appropriate container according to the material used (for example, plastic packaging into the yellow container). In this way, you reduce the amount of waste and enable further processing of the material in the recycling chain.