Before the first filling, we recommend thoroughly rinsing the packaging with a suitable cleaning blend, then with clean water and allowing it to dry completely. To ensure the hygiene and stability of the final product, it is advisable to rinse the inner surface and disinfect the spray dispenser with an alcohol-based preparation, for example isopropyl alcohol or ethanol. Only after the alcohol has completely dried and evaporated is the bottle ready to be filled with the chosen formulation.

The packaging can be reused if proper hygiene principles are followed. Before each new filling, it is important to clean and disinfect both the medicine bottle and the spray mechanism thoroughly in order to minimize the risk of microbial contamination and product spoilage. For disinfection, we recommend using alcohol-based preparations, for example IPA 99 % isopropyl alcohol or ethanol 96 % denatured vegetable. After treatment, allow the packaging to dry completely and only then fill it again.

Plastic packaging of this type is intended primarily for filling products at normal room temperature or slightly reduced temperature. It is not recommended to fill the bottle with hot blends or to expose it to higher temperatures during sterilization or heating in order to avoid damage to the walls of the packaging or to the spray mechanism. When using concentrated or more aggressive substances, we recommend performing an individual compatibility test with your formulation.

The filled packaging should be stored in a dry place, protected from direct sunlight and sources of heat. A stable environment without significant temperature fluctuations helps protect the properties of both cosmetic and technical preparations. During storage and transport, make sure the spray dispenser is tightly screwed on so that accidental leakage of the contents or air ingress into the system does not occur.

If you decide not to reuse the packaging, we recommend emptying it, rinsing out product residues and then placing it in sorted waste according to the recycling marking, which you will find in the product parameters. It is advisable to separate the body of the bottle and the spray dispenser according to the material type, thereby supporting more efficient processing in the recycling process. Always follow local waste sorting rules and the information given for the specific packaging on the product page.

To quickly find suitable packaging, we recommend using the advanced filter in the packaging materials category. After clicking on the relevant category, the filter is located at the top of the page and enables clear sorting according to several parameters. You can select, for example, the type and diameter of the neck, the size of the packaging, the colour and the material used, which allows you to easily narrow down the range to packaging that meets the needs of your specific product.