This type of packaging is intended primarily for products that are to be dispensed in the form of a fine foam. These are mainly foaming facial and body cleansers, liquid soaps, shaving foams and special cleansing and hygiene solutions. It is important that the formulation has a suitable viscosity for the foaming pump and does not clog its mechanism. Before serial filling, we always recommend testing the foaming ability and dispensing on a small trial batch.

The packaging can be reused if basic hygiene principles and appropriate handling are observed. Before each new filling, the bottle and the pump must be thoroughly cleaned and disinfected, ideally using high-percentage alcohols such as isopropyl alcohol or ethanol. For disinfection we recommend products available at Handymade – for example IPA 99 % isopropyl alcohol or ethanol 96 % denatured plant-based. After cleaning, allow all parts to dry completely so that your formulation is not diluted or otherwise affected.

If you decide not to reuse the packaging, we recommend disposing of it in the most environmentally friendly way possible. First, use up the contents or rinse out any remaining product as much as possible. Then separate the bottle and the foaming pump into individual parts according to the material specified in the parameter table for the product (for example, the bottle body and the pump mechanism may be made of different plastics). Plastic parts are sorted into containers intended for plastics according to local waste collection rules. Metal springs or mixed parts that cannot be separated should be disposed of according to the recommendations of the local municipal waste collection. Always follow the recycling symbols given for the product and the recommendations of your local recycling centre or municipality.

For the proper function of the foaming pump, a suitable formulation is important – it is generally a rather thin, watery or lightly gel-like formulation containing surface-active substances that create a stable foam. Too thick gels, a high proportion of insoluble particles or plant powders can clog the mechanism. It is recommended to prepare a trial batch, fill a smaller amount into the bottle and test the dispensing, the consistency of the foam and the stability during repeated use. Also make sure that the pump is screwed on evenly and that the seal sits correctly on the neck of the bottle.

To select suitable packaging, we recommend using the extended filter in the packaging material categories. After clicking on the relevant category, the extended filter is located at the top of the page and allows clear filtering according to several parameters. You can choose the packaging according to the type of neck, size, colour or material, thanks to which you will quickly find the bottle, dropper bottle, jar or container that will best suit your specific product and method of use.