Yes, with suitable handling and proper cleaning the packaging can be used repeatedly for similar types of cleaning preparations. However, before each new filling it is essential to thoroughly clean the bottle and the sprayer and then disinfect them, ideally using isopropyl alcohol or ethanol. For hygienic disinfection you can use, for example, the products IPA 99 – isopropyl alcohol or Ethanol 96 % denatured, plant-based. Disinfection helps to minimize the risk of microbial contamination and undesirable reaction between residues of the original and the new product.

After emptying the contents, first rinse the container several times with clean water to remove residues of the original preparation. Then rinse the sprayer itself – it is recommended to fill the bottle with clean water, spray briefly and thus flush the internal system. After mechanical cleaning it is appropriate to disinfect the internal surfaces and the sprayer using a suitable alcohol (for example IPA 99 or Ethanol 96 %) and allow it to dry thoroughly at room temperature. Packaging prepared in this way is suitable for further filling.

The packaging is primarily intended for common household and utility cleaning preparations. For formulations with a higher concentration of solvents, acids or alkalis, we recommend always performing an individual compatibility test – fill a small amount of the product, let it stand for a certain time and observe any changes on the material of the bottle and sprayer (softening, colour change, leakage). If possible, choose the composition of the preparation so that it is gentle on the plastic used and the sealing components in the dosing mechanism.

If you decide not to use the packaging further, we recommend first rinsing it thoroughly so that no residues of cleaning agent remain. Then follow the recycling instructions listed in the parameter table for the product, where the material used and the recommended sorting method are specified. In most cases the plastic bottle is placed in the container designated for plastic waste, and it is advisable to separate the container itself and the sprayer if they are made from different types of plastic. Local waste sorting rules may vary slightly, so always follow the sorting system in your municipality or city.

To make it easier to choose a suitable bottle, jar or other packaging, you can use the advanced filter located in the upper part of the page after clicking on the relevant packaging category. In the advanced filter you can clearly set parameters such as type and neck diameter, size and volume of the packaging, colour or material used. By filtering you narrow down the offer to packaging that best matches the required dosing mode, appearance and technical requirements of your product, and thus you more easily find the optimal solution for your formulation.