PRESERVATIVES
Euxyl PE 9010, Preservative, 1000 ml
Pack size10 ml50 ml100 ml1 l5 l
Euxyl PE 9010 is a liquid preservative blend of Phenoxyethanol and Ethylhexylglycerin that protects cosmetic products against bacteria, yeasts and moulds . full description
Lowest price in the last 30 days: €57.74
Product description
Euxyl PE 9010 is a liquid preservative blend of Phenoxyethanol and Ethylhexylglycerin that protects cosmetic products against bacteria, yeasts and moulds. The Ethylhexylglycerin boosts the effect of the Phenoxyethanol, so the blend preserves more effectively than Phenoxyethanol alone. It works in acidic, neutral and alkaline environments and is used in both rinse-off and leave-on products. It does not contain parabens.
How it preserves
The main work is done by Phenoxyethanol, which makes up roughly nine tenths of the blend. Ethylhexylglycerin affects the surface tension at the cell membrane of microorganisms, so the Phenoxyethanol then acts more strongly.
The manufacturer’s tests show the difference compared with Phenoxyethanol alone. In the determination of the minimum inhibitory concentration, 0.25–0.5% of the blend was enough to stop the growth of the tested strains. Phenoxyethanol alone required 0.25–1.0%. For staphylococci, the blend worked at half the concentration.
The manufacturer’s repeated challenge tests produced similar results. A carbomer gel with 0.6% of the preservative remained free of microbial growth throughout all six inoculation cycles. Gels with either 0.6% or 0.8% of Phenoxyethanol alone failed. In a moisturising soothing balm, 0.5% was not enough, and only 1.0% protected the product.
The effect needs time. Destroying microorganisms in a product that is already contaminated requires at least 48 hours of contact. The foundation remains hygienic production and raw materials with a low microbial load.
Usage rate
The recommended usage rate is 0.5–1.0%, the same for rinse-off and leave-on products. In creams, body lotions and serums, 0.6–1% is used more often, and in shampoos and conditioners even less. For emulsions and richer products, allow for the upper end of the range, as the balm test showed.
In the EU, Phenoxyethanol is permitted at up to 1% in the finished product. This corresponds to a maximum of 1.11% of this preservative.
Use in formulations
It is added to the cooled mixture or afterwards to the finished base. The processing temperature should be below 80 °C, and it is usually stirred in at 40 °C or lower. When the phases are heated to 65–70 °C, it is set aside. In cold water-based systems, such as toners or sprays, it is added directly to the water phase and stirred until homogeneous.
It dissolves in water only to a limited extent. At 20 °C the solubility is 10 g/l, which is about 1%. The recommended usage rate is therefore close to the solubility limit, and water-based products need to be mixed thoroughly. It dissolves well in glycols and in alcohol. You can pre-mix it with a glycol or with glycerine so that it disperses evenly.
It is not demanding with regard to pH. It is stable against hydrolysis, temperature and pH, and it works in formulations with a pH below 12, so there is no need to adjust the pH of the product because of it. The raw material itself has a pH of 6–8 in a 10 g/l solution.
Suitable for products such as
- Creams, body lotions and balms – leave-on emulsions for the face, body, hands and feet
- Serums, toners and clear gels – the preservative is clear and colourless, so it is also suitable for clear products
- Shampoos, conditioners, shower and bath products – rinse-off products for hair and body, including soaps
- Deodorants and antiperspirants
- Intimate hygiene products
- Decorative cosmetics
Good to know
- Ethoxylated surfactants – in rinse-off products with a high content of PEG surfactants, the efficacy is lower. Non-ionic emulsifiers bind Phenoxyethanol into micelles, leaving less of it free against microorganisms. In such products, do not use the lower end of the range.
- Composition of the oil phase – the preservative works in the water phase, where microorganisms grow. With polar oils and a high proportion of oil, less of it remains in the water and the protection is weaker.
- Moulds – they are the most resistant to Phenoxyethanol. For high-risk products, we recommend verifying efficacy with a challenge test.
- Oxidising agents – they are not compatible with the preservative.
- Materials when handling the concentrate – the undiluted preservative is compatible with stainless steel, brass, copper, zinc, aluminium, polyethylene (PE), polyoxymethylene (POM), polyamide (PA) and rigid PVC. We recommend testing other non-metallic materials beforehand.
- Origin and certifications – the raw material is of synthetic origin, is manufactured in the USA and holds Vegan certification. The manufacturer holds a Halal certificate.
At temperatures below 5 °C, the preservative may solidify or crystallise. Warm it gently to 40–45 °C and mix thoroughly before use.
The concentrate is classified under CLP and carries the GHS05 and GHS07 pictograms. When handling it, protect your skin and eyes, ensure ventilation and do not create an aerosol.
Frequently asked questions
Parameters
- INCI
- Phenoxyethanol, Ethylhexylglycerin
- CAS No.
- 122-99-6, 70445-33-9
- EC number
- 204-589-7, 408-080-2
- Product colour
- Colourless
- Country of origin
- USA
- Grade
- Cosmetic grade
- Processing method
- BlendingChemical synthesis
- Odour
- Characteristic
- Appearance
- Liquid
- Function in formulation
- Preservative
- Formulation phase
- Cool-down phasePost-addition
- Recommended processing temperature
- < 80 °C
- Recommended usage rate
- 0,5 – 1,0 %
- Recommended formulation pH range
- < 12
- Effects
- Antimicrobial effect
- Suitable for
- All skin types
- Biodegradability
- Inherently biodegradable
- Certifications and declarations
- Vegan
- Manufacturer's certificate
- Halal
- Natural Index (NI ISO 16128)
- 0,00
- Natural Origin Index (NOI ISO 16128)
- 0,00
- Volume
- 1000 ml
Product documentation
- TDSTechnical Data Sheet
- PDF ↓
- SDSSafety Data Sheet
Learn how to work with it
From our blogMy favourite preservative.
Translated automatically
I'm discovering it.
Translated automatically




























