Yes, the glass bottle with dropper is suitable for home and professional cosmetic formulas, especially for oil serums, elixirs, intensive treatment blends and concentrated active solutions. We always recommend verifying the compatibility of the specific formulation with the packaging using a test batch and monitoring the stability of the product during storage.

The bottle can be reused if hygienic principles are followed. Before each new filling, the packaging must be thoroughly cleaned and then disinfected with a suitable alcohol, for example with the products IPA 99% isopropyl alcohol or Ethanol 96% denatured vegetal. After disinfection, allow the bottle and the dropper to dry completely to minimise the risk of microbial contamination of the new batch of product.

We recommend disassembling the dropper into the accessible parts after emptying the contents and rinsing them with a suitable cleaning solution or warm water with a mild detergent that does not damage the rubber or plastic parts. Then rinse the components with clean water, disinfect them with alcohol and let them dry completely on a clean absorbent surface. Before the next use, always check the suction performance and the sealing of the dropper.

If you decide not to reuse the bottle, we recommend, after emptying and basic cleaning, sorting it into the separate waste stream according to the material specified in the product parameters. The glass body of the medicine bottle is usually placed into the container designated for glass; the plastic and rubber parts of the closure or dropper must be separated according to the local waste sorting rules. Before discarding, remove any product residues and ensure that the packaging is disposed of in accordance with local recycling recommendations.

To choose suitable packaging, you can use the advanced filter located at the top of the page after clicking on the relevant packaging category. In the filter it is possible to combine several criteria – for example the type and size of the neck, the desired packaging size, colour or material. Thanks to this, you can easily narrow the offer down to bottles, jars or pots that meet the technical and design requirements of your product.

When working with concentrated active substances or essential oils, we recommend following the formulation recommendations of the raw material supplier and always preparing a trial batch. Monitor changes in colour, odour, viscosity or any possible sedimentation. It is also important not to overfill the bottle, to leave a small headspace and, after closing, to check the sealing of the dropper. In the case of longer-term storage, place the packaging in a dry, cooler place protected from direct sunlight.