Yes, the glass dropper bottle with dropper is suitable for concentrated preparations where precise drop-by-drop dosing is important. Stable glass reduces the risk of undesirable interactions between the packaging and the contents, and the dropper facilitates controlled application. However, for highly reactive or atypical formulations, we always recommend performing your own compatibility test and monitoring the behaviour of the product in the packaging over time.

The bottle can be reused provided strict hygiene principles are followed. Before each new filling, the packaging must be thoroughly cleaned and then disinfected with a suitable agent, for example isopropyl alcohol or ethanol. For disinfection you can use the products IPA 99 % isopropyl alkohol 1 l or Etanol 96 % denaturovaný rastlinný 1 l. After disinfection, allow the bottle and the dropper to dry completely and only then refill it, ideally with the same type of product, to avoid mixing residues of different formulations.

Clean the dropper separately from the glass part of the bottle. First rinse it with a suitable cleaning agent and warm (not boiling) water to remove product residues. Then it is advisable to disinfect using alcohol and allow all parts to dry thoroughly. Avoid aggressive mechanical cleaning that could damage the seal or the dosing part itself. Before re-use, always check that the dropper seals properly and doses evenly.

To select suitable packaging, you can use the advanced filter located at the top of the page after clicking on a specific packaging category. In the advanced filter you can clearly choose parameters such as neck type, size, colour and packaging material. This allows you to quickly find bottles, dropper bottles, jars or other containers that will meet the technical and design requirements of your product.

If you decide not to reuse the packaging, its recycling is recommended according to the rules stated for the product in the parameter table. The glass part of the bottle is usually sorted into the container designated for glass, while the plastic and rubber parts of the dropper belong to plastic or mixed waste according to local rules. Before handing it over for separate collection, empty the packaging as much as possible and remove any product residues. This supports efficient recycling and reduces the burden on the environment.