Yes, the packaging can be used repeatedly if hygienic principles are followed. Before each new filling, it is important to thoroughly clean and disinfect both the bottle and the spray pump in order to minimize the risk of microbial contamination and spoilage of the product. For disinfection we recommend using high-percentage alcohol, for example IPA 99 % or 96 % denatured ethanol, which you will find in the offer as IPA 99 – isopropyl alcohol and Ethanol 96 % denatured plant-based. After treatment with alcohol, allow all parts to dry completely and only then refill the packaging.

The bottle with spray pump is most suitable for low-viscosity liquids that need to be gently sprayed in a thin layer or as a mist – typically facial and body waters, hydrosols, hair sprays, aromatherapeutic mists and air or fabric fresheners. For thicker emulsions or highly viscous oils, we recommend performing a dosing test before final use to verify whether the spray mechanism provides smooth and even application of the product.

Before refilling, it is advisable to disassemble the bottle and the spray mechanism into the accessible parts, rinse them with warm water and a suitable detergent, rinse thoroughly and then disinfect with an alcohol solution. For disinfection you can use, for example, the products IPA 99 – isopropyl alcohol or Ethanol 96 % denatured plant-based. After treatment, let all parts air dry on a clean surface so that no water remains in the system, which could affect the stability of the new fill.

To make it easier to select suitable packaging, you can use the advanced filter available at the top of the page after clicking on the relevant packaging category. Using the filter, you can sort the range by neck type, size, colour and material, and thus adapt the selection to the specific requirements of your product and dosing. We recommend starting by choosing the base material (glass, plastic), then selecting the volume and neck according to the planned caps or dispensing components, and only afterwards fine-tuning the design details such as colour or surface finish.

Before finally implementing the packaging in production, we recommend preparing a test sample of the product and filling it into one bottle with spray pump. Over a period of several days to weeks, monitor the behaviour of the contents, the functionality of the mechanism, the sealing and any changes in fragrance, colour or consistency. Pay particular attention to formulations with a high content of alcohols, essential oils and acidic or alkaline components. If no changes occur and dosing remains stable, you can consider the packaging suitable for that type of product.

If you decide not to reuse the packaging, we recommend placing it in sorted waste according to the material of the individual parts, in line with the information given in the product parameters. After emptying and basic cleaning, the glass bottle should normally be placed in the container intended for glass. The plastic and metal components of the spray pump should be separated and sorted according to local rules for the collection of plastics and metals. Before disposal, make sure that no residues of concentrated or hazardous substances remain in the packaging; these must be handed over in accordance with the guidelines for handling chemicals in your region.