GLASS BOTTLES 15 ml
White Glass Bottle, Glossy Golden Black Pump with Smoky Overcap, 15 ml
Pack size10 ml15 ml30 ml100 ml
Serums, facial oils and light emulsions need packaging that protects the contents from light while allowing a small amount to be measured out precisely. full description
Lowest price in the last 30 days: €2.02
Total for 1 pcs: €2.02
Quantities add up across all combinations of this bottle.
Product description
Serums, facial oils and light emulsions need packaging that protects the contents from light while allowing a small amount to be measured out precisely. This set combines a white glass medicine bottle with a nominal volume of 15 ml with a glossy black and gold pump with a smoky overcap; the pump dispenses the same dose with every press. White glass is opaque, so no light reaches the contents and neither their colour nor any discolouration over time shows. The 15 ml volume matches the usual size for serums, eye contour oils, concentrates or samples, which are dosed by the drop rather than by the spoonful.
What it is suitable for
The pump with a dip tube draws the contents from the bottom of the bottle, so it works reliably with liquid and slightly thicker formulations. It is particularly suitable for:
- Facial serums and concentrates – water-based and gel serums of lower viscosity are dispensed evenly, without fingers touching the contents.
- Facial and hair oils – oil serums and blends of vegetable oils for the face or hair ends, where the dose corresponds to the amount for a single use.
- Light emulsions and fluids – thin O/W emulsions, fluids for the eye and décolleté area, or primer bases for make-up.
- Samples and travel packs – the small volume and spill-free dispensing are suitable for testing formulations or for gift sets.
Thick creams, butters and balms do not belong in this packaging. The tube will not draw them up and the pump becomes clogged after a few presses. Before filling larger quantities, check how your specific formulation behaves using a single piece.
Dispensing and volume
One press dispenses approximately 0.14 ml. When filled to the nominal volume, this corresponds to roughly one hundred doses. The smoky overcap protects the pump head from dust and accidental pressing in a handbag or while travelling.
When filling, two figures need to be distinguished. The nominal volume of 15 ml is the amount the bottle is intended for during normal filling. The total brimful volume, given in the parameters, is the physical volume up to the neck. The difference provides a reserve for the tube and the body of the pump, which push part of the contents upwards when screwed on, and for any expansion of the contents. Fill to the nominal volume, not to the brim, otherwise the contents will overflow when the pump is fitted.
The pump tube is longer than the height of the bottle requires. Before first use, shorten it with a diagonal cut so that it ends just above the bottom. A slanted end will not stick to the bottom and the pump will draw up even the last millilitres.
Preparation and reuse
Before first filling, wash the bottle, disinfect it with isopropyl alcohol or ethanol and leave it to dry completely. It is enough to pump clean alcohol through the pump several times and then pump it empty, so that all the liquid leaves the tube and the mechanism. Residual water in the pump can spoil an anhydrous oil product.
After thorough cleaning, the glass bottle can be refilled repeatedly. The pump is harder to rinse. When changing the formulation, it is better to replace it so that residues of the previous product do not get into the new contents. Do not clean the glossy black and gold head with abrasive products.
Glass withstands oils, alcohol and essential oils. The pump is made of a combination of plastic and aluminium. For formulations with a higher proportion of essential oils or solvents, check that the material does not change its appearance or tightness in the long term.
With glass packaging, avoid sudden temperature changes. A hot emulsion poured into a cold bottle, or rapid cooling of a filled bottle, can crack the glass. Let the product cool to room temperature before filling.
Good to know
The glass bottle has a declaration of suitability for contact with cosmetic products. No such declaration has been issued for the pump, so check its compatibility with your specific formulation in practice. The set is not approved for contact with food and should not be used for home-made food oils or syrups.
You will find closures with the same neck type as the bottle in the Handymade range, together with other ready-made combinations. If you make your own combination of packaging and closure, check the tightness, dispensing and behaviour with your specific contents.
At the end of its life, the glass bottle is sorted into glass waste. The pump consists of several materials and is separated from the bottle before disposal.
Frequently asked questions
Parameters
Glass bottle, vial, white, 15 ml
Product documentation
Verified by customers.
No reviews yet.
Only customers with a delivered order can write reviews.























































































