GLASS BOTTLES 15 ml
White Glass Bottle, Glossy Gold White Spray, 15 ml
Pack size10 ml15 ml30 ml100 ml
The white glass medicine bottle with a 15 ml volume and a glossy white and gold fine mist sprayer is suitable for small packs of face and hair mists, toners, hydrosols and perfume waters that are applied by spraying. full description
Lowest price in the last 30 days: €1.91
Total for 1 pcs: €1.91
Quantities add up across all combinations of this bottle.
Product description
The white glass medicine bottle with a 15 ml volume and a glossy white and gold fine mist sprayer is suitable for small packs of face and hair mists, toners, hydrosols and perfume waters that are applied by spraying. The opaque white glass conceals the contents and reduces light exposure, so even formulations that are more sensitive to light keep well in it. The light surface of the glass together with the glossy sprayer gives the finished product a clean look.
The set is declared suitable for contact with cosmetics. Neither the bottle nor the sprayer has a food-contact certificate, so it is intended exclusively for cosmetic products.
How the set dispenses
The sprayer delivers approximately 0.14 ml per press, so a full bottle gives you over a hundred sprays. A dose like this is enough to refresh the face with a toner or hydrosol, or for one application of perfume water, without the contents running off. The sprayer is designed for thin, water-based and alcohol-based liquids. Thicker formulations and oils spray less well from it and often come out as a stream instead of a mist, so test how the sprayer behaves with them before filling a whole batch.
The dip tube is supplied longer than the height of the bottle. Before first use, shorten it so that it reaches just to the bottom, preferably with an angled cut, so that it does not sit flat on the base and draws up even the last millilitres.
After filling, press the sprayer several times to prime it until the tube fills with the contents. Only then does it dispense fully.
Nominal and total volume
The nominal volume is the volume the bottle is intended for in normal filling. The brimful capacity is the physical volume up to the neck and you will find it in the parameters. The difference between them is a reserve for the tube and the inner part of the sprayer, which take up some of the space once screwed on. Fill only up to the nominal volume. If overfilled, the contents are pushed out through the thread after the sprayer is screwed on and the bottle does not seal.
What it is suitable for
- Face and hair mists – low-viscosity water-based formulations that are spread evenly over the skin or hair by spraying.
- Hydrosols and toners – a small pack for travel, for a handbag, or as a trial size before a larger pack.
- Perfume waters and alcohol-based mists – 15 ml corresponds to a travel pack. With a high alcohol content, check how the sprayer behaves with your specific formulation over a longer period, not only in the first test.
- Samples and test batches – the volume makes it possible to divide one batch into several units for customers or for stability tests.
Good to know
- Preparation before first filling – wash the bottle, disinfect it with isopropyl alcohol or ethanol and leave it to dry completely. Rinse the sprayer by spraying clean water through it and leave it to dry with the tube facing down.
- Filling – pour the cooled formulation into the bottle; a funnel helps with a narrow neck. Do not expose the sprayer, which has plastic parts, to hot contents.
- Reuse – the glass can be used again after washing and disinfection. Rinse the sprayer with water and by spraying, but when changing the fragrance composition, expect some residual fragrance in the plastic parts.
- Essential oils and solvents – for formulations with a higher proportion of essential oils or other solvents, check whether they change the plastic parts of the sprayer and the seal over the long term.
- Closures – sprayers and closures with the same neck finish as stated in the parameters, and other ready-made bottle + closure combinations, can be found in the Handymade range. If you make your own combination, check the seal, the dispensing and the behaviour of the packaging with your specific formulation.
- Recycling – the glass bottle belongs in glass recycling. The sprayer combines polypropylene and an aluminium part, so separate it from the bottle before disposal.
The sprayer seals only on a clean, dry thread. Before screwing it on, wipe the neck of the bottle clean of any formulation residue, otherwise the contents may leak out during transport.
Frequently asked questions
Parameters
Glass bottle, vial, white, 15 ml
Product documentation
Verified by customers.
No reviews yet.
Only customers with a delivered order can write reviews.























































































