Amber Plastic Bottle, Black Lotion Pump with Black Overcap, 50 ml

Plastic bottle, vial, cream dispenser with a black cap, 50 ml is a ready-made packaging and closure set for creams, lotions, serums and gels that you want to dispense hygienically without finger contact with the contents. The brown PET bottle is lightweight and shatterproof, and its dark colour filters light. The black cream dispenser with a dip tube delivers a small, repeatable dose with each press, making it particularly suitable for products where precise dosing matters.

The set is intended for cosmetic products. Both the bottle and the dispenser are declared suitable for contact with cosmetics. The bottle alone holds a certificate for direct food contact; the complete set as a whole is not intended for food use.

Suitable for products such as

• Facial creams and light emulsions – one press corresponds roughly to the amount typically applied to the face, without scooping with fingers from a jar.
• Serums and gels – water-based and hydrogel textures pass through the tube without issue, and the small dose prevents wasting concentrated active ingredients.
• Body lotions and hand lotions in travel size – the 50 ml volume is practical for trial packaging, gift sets or on-the-go use.
• Oil serums and oil blends – liquid oils dispense easily. With contents containing a higher proportion of essential oils or solvents, we recommend testing plastic compatibility with the specific formulation in advance.

How the dispenser works

The dispenser screws onto the bottle neck and draws the contents up through a dip tube from the bottom, so the bottle can be emptied almost completely. One press delivers approximately 0.14 ml. This allows the product to be dispensed economically and the dose is easy to repeat.

The pump with dip tube is not an airless system. Each press draws air into the bottle, so water-based formulations filled into this set should be properly preserved and stabilised, just as they would be in a standard bottle.

What is good to know when filling

Nominal volume is the volume for which the packaging is designed under normal filling conditions. The total capacity to the brim is the physical volume up to the neck and is slightly larger. The difference provides a reserve for the dispenser tube and for expansion of the contents with temperature changes. Fill to the nominal volume, not to the brim; otherwise, some of the contents will be pushed out when the dispenser is screwed on.

Before first use, we recommend washing both the bottle and the dispenser, disinfecting with isopropyl alcohol or ethanol and allowing them to dry completely. Residual water in the tube would dilute the first doses. The bottle can be reused if cleaned thoroughly. The dispenser is cleaned by pumping through warm water and then alcohol; however, after a change of fragrance or a coloured product, it is more reliable to replace it with a new one. PET tolerates normal temperatures when filling cold. Hot filling of creams immediately after emulsification is not suitable — allow the contents to cool first.

For recycling, the PET bottle and the polypropylene dispenser are sorted as plastic. As they are two different materials, we recommend separating them before disposal.

Closures with the same neck type, listed in the specifications, and other ready-made combinations are available in the Handymade range. When creating your own combination, we recommend verifying the seal, dosing and packaging behaviour with the specific formulation.

Frequently asked questions