GLASS BOTTLES up to 10 ml
Blue Glass Bottle, Black Lotion Pump with Black Overcap, 10 ml
Pack size10 ml15 ml30 ml50 ml100 ml
Blue glass bottle with a capacity of 10 ml and a fitted lotion pump , which dispenses a small, roughly equal amount of the contents with each press. full description
Lowest price in the last 30 days: €0.68
Save €0.05 with this set
Total for 1 pcs: €0.68
Quantities add up across all combinations of this bottle.
Product description
Blue glass bottle with a capacity of 10 ml and a fitted lotion pump, which dispenses a small, roughly equal amount of the contents with each press. The coloured glass blocks part of the light, so it is suitable for creams and serums with light-sensitive active ingredients. The set is designed for small packs: eye creams, concentrated serums, topical products or samples, where the contents are dispensed in small amounts and should not come into unnecessary contact with fingers and air.
The black plastic pump screws onto the bottle like an ordinary cap. Both the bottle and the pump are declared suitable for contact with cosmetic products, and you will find the declaration of conformity with the product.
What it is suitable for
- Eye creams and lip creams – the small dose per press corresponds to the amount normally applied to these areas.
- Serums with active ingredients – the coloured glass limits the effect of light on ingredients such as vitamin C or retinol, and the pump limits contact of the contents with air.
- Samples and travel packs – a volume of 10 ml is enough to try out a formula or for a few days away from home.
- Topical products – gels and light creams for small areas of skin, where they are dispensed precisely and in small amounts.
Dispensing and filling
The pump dispenses approximately 0.14 ml per press, which corresponds to a small drop of cream. Before first use, the pump needs to be primed: after screwing it on, press it several times until the tube fills and the contents start to come out.
The pump tube is supplied longer than the height of the bottle. Before fitting it, shorten it with a sharp knife or scissors so that it reaches just above the bottom. A tube that is too long bends inside the bottle and the pump draws in air, while one that is too short leaves an unused residue at the bottom.
When filling, follow the nominal volume, that is 10 ml. The nominal volume is the amount the packaging is designed for under normal filling. The brimful capacity given in the parameters is the physical volume of the bottle up to the neck. The difference provides a reserve for the inserted pump tube and for the expansion of the contents when the temperature changes. If the bottle is filled to the brim, the contents overflow when the pump is screwed on and the thread gets dirty.
Good to know
The lotion pump is designed for liquid to medium-thick emulsions. Light creams, facial lotions, serums and gels pass through the tube without difficulty. A thick cream or an ointment with a high proportion of butters will not be drawn up by the pump, or may clog it. Very runny toners, on the other hand, spatter when pressed. We recommend testing the behaviour of your particular formula on one piece before filling a whole batch.
The pump is not an airless system. Air is drawn into the bottle with every press, so a formula with a water phase needs a functioning preservative system, just as in a jar. For anhydrous oils, a dropper or a fine mist sprayer is more suitable.
Before the first filling, wash the bottle, disinfect it with isopropyl alcohol or ethanol and let it dry completely. Rinse the pump with clean water, pump it several times and let it dry as well. After thorough washing and disinfection, the glass bottle can be reused. The pump is worth reusing only with the same type of contents, because residues of cream inside the mechanism are difficult to clean.
The glass withstands disinfection with alcohol and hot water, but avoid sudden changes in temperature so that it does not crack. The pump is made of polypropylene (PP). With concentrated essential oils or formulas with a higher proportion of alcohol, we recommend checking that the mechanism dispenses consistently even after several weeks.
The bottle has a neck with an 18 mm thread. You will find other closures with the same type of neck, as well as ready-made combinations, in the Handymade range. If you are making your own combination, test the tightness and dispensing with your particular formula.
Frequently asked questions
Parameters
Glass bottle, vial, blue, 10 ml
Product documentation
Verified by customers.
No reviews yet.
Only customers with a delivered order can write reviews.





















































































