GLASS BOTTLES 30 ml
Amber Matte Glass Bottle, Glossy Silver White Pump, 30 ml
The matte amber medicine bottle with pump is a ready-made set for 30 ml of facial serum, oil or light emulsion. The contents are dispensed by pressing the pump, without opening the bottle. full description
Lowest price in the last 30 days: €1.25
Save €0.03 with this set
Total for 1 pcs: €1.25
Quantities add up across all combinations of this bottle.
Product description
The matte amber medicine bottle with pump is a ready-made set for 30 ml of facial serum, oil or light emulsion. The contents are dispensed by pressing the pump, without opening the bottle. Amber glass limits the light reaching the contents, so the set suits formulations with light-sensitive ingredients, for example vitamin C serums, retinol fluids or oils prone to oxidation. The white and silver pump with a glossy finish gives the bottle a uniform look and delivers the same amount with every press.
The set is declared as suitable for contact with cosmetics. It is not intended for food.
What it is suitable for
- Facial serums and fluids – liquid to medium-thick formulations where an exact dose matters and the contents should not come into contact with fingers or air more than necessary.
- Facial and body oils – dark glass slows down changes caused by light, and one to two presses of the pump measure out enough for a facial treatment.
- Light emulsions and facial lotions – if they are sufficiently fluid, the pump dispenses them evenly until the bottle is empty.
- Samples and travel packs – a volume of 30 ml is enough for several weeks of using a serum, or for testing a formulation before a larger batch.
Dispensing and filling
One press delivers approximately 0.14 ml, which corresponds to a typical serum dose for one application. The pump draws the contents up from the bottom through a dip tube, so the bottle does not need to be tilted, and less air gets into the contents than when a cap is opened. Check the length of the dip tube before fitting the pump. If it reaches past the bottom, shorten it with an angled cut so that the end sits just above the bottom and does not bend. On first use, press the pump several times until the dip tube fills and the contents start to come out.
The volume of 30 ml is nominal, that is, the volume the bottle is designed for under normal filling. The brimful capacity is the physical volume up to the neck and can be found in the parameters. The difference between them is a reserve for the dip tube and the pump body, and for the expansion of the contents when the temperature changes. Fill the bottle to the nominal volume, not to the brim, otherwise the contents will overflow when the pump is screwed on.
Before the first filling, wash the bottle and the pump, disinfect them with isopropyl alcohol or ethanol and let them dry completely. Residual water in the dip tube would dilute the first doses and could cause cloudiness in anhydrous oil formulations.
Good to know
- Viscosity of the contents – the pump is designed for liquid to medium-viscosity contents. Thick creams, butters and high-viscosity gels may not be drawn up the dip tube or may come out unevenly. Test the behaviour with your specific formulation before filling the whole batch.
- Plastic and formulation – the pump is made of polypropylene and aluminium. For formulations with a high proportion of essential oils, alcohol or solvents, check after several weeks that the seal and the dip tube do not change shape and that there is no leakage.
- Glass and heat – do not fill the bottle with a hot oil phase or a freshly mixed emulsion. Let the contents cool to room temperature. A sudden temperature change puts stress on the glass, and warm contents would draw air into the bottle as they cool once closed.
- Reuse – the glass can be washed and used again. Rinse the pump with warm water and a small amount of washing-up liquid and pump it several times so that the dip tube and the valve are cleaned as well. If residues of oil or dye remain in it, it is better to replace it for the next batch.
- Closures – the pump is part of the set. You can find other closures with the same neck type and ready-made combinations in the Handymade range. If you make your own combination, check the tightness and dispensing with your specific formulation.
- Recycling – the bottle is glass and is sorted with glass. The pump combines plastic and aluminium; before disposal, unscrew it from the bottle and sort it separately.
A small layer of contents always remains below the end of the dip tube, which the pump can no longer draw up. With more expensive active ingredients, take this into account when calculating the doses per pack.
Frequently asked questions
Parameters
Glass bottle, matte brown, 18 mm, 30 ml
Product documentation
Verified by customers.
No reviews yet.
Only customers with a delivered order can write reviews.




























































































