GLASS BOTTLES 30 ml
Blue Glass Bottle, Oil Pump, 30 ml
Pack size10 ml15 ml30 ml50 ml100 ml
This 30 ml glass bottle with a treatment pump solves two problems at once. Blue glass lets through less light than clear glass, and the pump dispenses the same small dose with every press, without dripping and without… full description
Lowest price in the last 30 days: €1.58
Total for 1 pcs: €1.58
Quantities add up across all combinations of this bottle.
Product description
This 30 ml glass bottle with a treatment pump solves two problems at once. Blue glass lets through less light than clear glass, and the pump dispenses the same small dose with every press, without dripping and without your fingers touching the contents. It suits face and hair oils, oil serums, beard oils, oil cleansers, cuticle blends and samples of massage oils. In all of these, one or two presses are enough for a single use. The set consists of a blue glass medicine bottle with an 18/410 neck finish, a black treatment pump with a dip tube and a clear overcap.
What the set is suited for
- Oil serums and face oils – with concentrated oils, a small and precise dose is worthwhile, and the contents do not spill or drip down the neck.
- Hair and beard oils – the pump delivers a few drops straight into your palm, even with one hand.
- Oil cleansers and cleansing oils – the bottle does not need to be opened in the bathroom. The contents come into contact with water and air less than when a cap is unscrewed.
- Samples and travel sizes – the 30 ml volume and the low medicine bottle shape have proven themselves for customer test packs.
The pump is designed for liquid oils and low-viscosity oil blends. With thicker oils, blends containing butters, or oils that solidify in the cold, check beforehand that the pump dispenses smoothly and that the dip tube does not clog.
How the pump works
One press dispenses approximately 0.18 ml of the contents, which equals a few drops. For a face oil, one to two doses are usually enough, and you can state this directly in the instructions for the finished product. The pump draws the contents up through the dip tube from the bottom, so the bottle is used in an upright position. On first use, press it several times until the tube fills.
The clear polystyrene overcap fitted over the pump head protects the opening from dust and prevents accidental pressing in a bag or during transport. Always fit the overcap before sending the finished product to a customer.
The pump's dip tube is longer than the height of the bottle. Before fitting, shorten it with an angled cut so that it reaches just above the bottom. It will then draw up the remaining contents as well and will not bend inside the bottle.
Filling and volume
The nominal volume is the volume the packaging is designed for under normal filling. The brimful volume stated in the parameters is the physical volume of the bottle up to the neck. The difference between them is a reserve for the dip tube and the pump body, which push part of the contents upwards once screwed in, and for the expansion of the oil with changes in temperature. Fill the bottle to the nominal volume, not to the brim. If it is overfilled, the oil overflows through the thread when the pump is screwed on, and the closure then does not seal.
Screw the pump onto a dry and clean thread. Oil on the thread impairs the seal, and the bottle may leak during transport.
Good to know
Before the first filling, wash the bottle, disinfect it with isopropyl alcohol or ethanol and let it dry completely. Rinse the pump in the same way and press it several times without any contents, so that the remaining alcohol runs out of the tube.
The glass bottle can be reused after thorough washing. The pump is harder to clean, because oil remains in the tube and in the valve. When changing the recipe or after prolonged use, we recommend a new pump, especially if the previous oil has started to turn yellow or change its scent.
Both the pump and the overcap are plastic. With blends containing a higher proportion of essential oils or added solvents, check in a stability test with your specific formulation that the plastic does not change colour, harden or crack.
The whole set is declared suitable for contact with cosmetic products. After use, the glass bottle belongs in glass recycling and the pump with the overcap in plastics recycling. Separate them from each other before disposal.
You can find closures with the same neck finish and other ready-made bottle and closure combinations in the Handymade range. If you make your own combination, check the seal, the dispensing and the behaviour of the packaging with your specific formulation.
Frequently asked questions
Parameters
Glass bottle, vial, blue, 18 mm, 30 ml
Black Plastic Oil Pump, 18 mm
Clear Plastic Cap for Oil Pump, 18/410
Product documentation
- DrawingTechnical drawing
- PDF ↓
Verified by customers.
No reviews yet.
Only customers with a delivered order can write reviews.





















































































