When selecting a suitable bottle, it is crucial that the neck and thread designation stated in the parameters of the cap and the bottle match. In the details of both products you will find information about the neck type, on the basis of which you can verify compatibility. We recommend choosing bottles from the same packaging category, where recommended combinations are also listed. Before final fitting onto a full container, it is advisable to perform a sealing and dosing test on a smaller amount of product.

The disc top cap is ideal for liquid and semi-liquid products that are used in smaller amounts and should be easily and quickly accessible. In practice it is most often used for facial waters, toners, makeup removing solutions, hair lotions, soap bases, body milks with a thinner consistency or various working solutions in cosmetic and craft production. It is always important to test the behaviour of the specific formula in contact with the packaging and the closure mechanism.

The cap can be used repeatedly in home and craft production provided you follow basic hygiene principles and regular cleaning. Before each new filling it is necessary to thoroughly clean the packaging and the closure and then disinfect them with a suitable alcohol-based product, for example using the products IPA 99 % isopropyl alcohol or Ethanol 96 % denatured vegetable. After disinfection, let all parts dry completely and only then use them again. This will reduce the risk of microbial contamination and extend the service life of the packaging.

After the contents of the bottle have been used up, we recommend dismantling the cap into the accessible parts, rinsing it in warm water with a mild detergent and then thoroughly rinsing it with clean water. For thicker or more oily formulations, multiple rinsing may be necessary to remove residues of oils and emulsifiers. Before further use it is advisable to disinfect the closure with an alcohol solution and let it dry completely. Avoid using aggressive cleaning agents that could damage the surface or the functionality of the mechanism.

If you decide not to reuse the cap, we recommend, after thoroughly emptying and cleaning it, assigning it for recycling according to the material composition given in the product parameters. In practice this means separating it from the bottle and sorting it according to local waste collection rules – metal and plastic parts go into the appropriate collection containers or to a collection point according to the instructions of your municipality. Before discarding, always check the material marking on the product and follow the recommendations in the parameter table so that the recycling process is as effective as possible.

For an easier selection you can use the advanced filter located at the top of the page after clicking on the relevant packaging category. In the advanced filter you can narrow down the range according to several parameters, such as neck type, packaging size, colour or material used. By combining these filters you will quickly find bottles, vials, jars or closures that will best suit your specific formula and the visual concept of the final product.