Yes, the packaging can be reused if handled appropriately. When refilling, it is important to follow hygiene principles – before each new use, the bottle, spray pump and all components must be thoroughly cleaned and then disinfected. For disinfection we recommend using, for example, isopropyl alcohol or ethanol intended for packaging hygiene, which you can find in the range as IPA 99 % isopropyl alkohol and Etanol 96 % denaturovaný rastlinný. Only after complete drying is the packaging ready for further use.

To make selection easier, we recommend using the advanced filter in the packaging material categories. After clicking on the relevant category, the filter is located at the top of the page and allows you to sort the offer according to several parameters – especially according to the type and size of the neck, the total volume or size of the bottle, the colour of the packaging and the materials used. Thanks to this, you can quickly filter packaging and compatible closures that will best correspond to your specific product and dosing method.

Before first filling, we recommend rinsing the bottle with a suitable cleaning agent and warm water, rinsing thoroughly and allowing it to dry completely. It is then advisable to carry out disinfection, for example using alcohol-based products such as IPA 99 % isopropyl alkohol or Etanol 96 % denaturovaný rastlinný. Leave the disinfectant solution to act briefly, pour off the excess and allow the bottle and spray pump to air dry so that no residual moisture remains in the packaging, which could affect the stability of your formulation.

This bottle with spray pump is suitable primarily for liquid formulations that require fine, even application in a thin layer. In practice it is used for facial and body sprays, refreshing waters, aromatherapeutic sprays for the body and interior, for hair tonics, special serums for the skin, as well as concentrated cleaning or technical solutions intended for precise and economical dosing. It is always important to test the behaviour of the specific formulation in contact with the packaging and with the spray pump itself.

If you decide not to reuse the packaging, we recommend prioritising recycling according to the material composition listed in the product parameters. The glass part of the bottle is usually placed, after emptying and basic rinsing, into the glass container. The spray pump and plastic components belong, depending on the type of plastic, in the appropriate sorted waste or in mixed waste if the local system does not collect that type of plastic. Before disposal it is advisable to remove product residues to facilitate recycling and reduce environmental impact.

Store filled bottles ideally in a dry, clean environment at stable room temperature and away from direct sunlight, unless your composition requires different conditions. Avoid extreme temperature fluctuations that could affect the stability of the product or the tightness of the spray pump. It is advisable to store the packaging in an upright position to minimise the risk of leakage and to ensure that the spray mechanism remains fully functional throughout the period of use.