When choosing packaging, we recommend using the advanced filter in the packaging category. After clicking on the relevant category (for example bottles, jars, medicine bottles), you will find the filter in the upper part of the page. There you can conveniently set the required parameters, such as neck type, size, colour and packaging material. This allows you to quickly narrow the selection down to packaging that is suitable for your specific product and method of application.

The packaging can be used repeatedly if hygiene principles are followed. Before each new filling, it is necessary to clean the packaging thoroughly by mechanical means, remove residues of the previous filling and then disinfect it. For disinfection we recommend using IPA or ethanol products, for example IPA 99 % isopropyl alcohol or Ethanol 96 % denatured plant‑based. After disinfection, allow the packaging to dry completely so that the stability of your new formulation is not compromised.

Before filling the entire batch, we recommend carrying out a small trial test. Fill a smaller amount of the finished formulation into the selected packaging and observe the behaviour of the packaging and the contents over several days to weeks. Check in particular the tightness of the closure, the functionality of the pump or sprayer, changes in consistency or fragrance and any discolouration or clouding of the walls of the packaging. If possible, perform the test also under conditions similar to actual use (transport, normal storage, repeated opening).

If you decide not to reuse the packaging, we recommend recycling it appropriately according to the type of material specified in the product parameters. Before handing it over for separate collection, remove any product residues, empty the packaging as much as possible and, if possible, rinse it. Then place it in the appropriate recycling container according to the symbol and material designation. Recycling instructions may differ depending on the local collection system, so it is advisable to also follow the recommendations of your local recycling centre or municipality.

When choosing a closure or dosing system, it is important to monitor the neck compatibility of the packaging and the closure, as well as the character of your formulation. Liquid and low‑viscosity products often require droppers or sprayers, while thicker creams and gels are better suited to pumps or disc top closures. In the recommended combinations on Handymade you will find packaging and closures that have been tested together. Nevertheless, before series filling we recommend verifying sealing, convenience of dosing and the behaviour of the product in the packaging during real‑life use.

Packaging should be stored in a dry, clean and dust‑free environment, protected from direct sunlight and significant temperature fluctuations. Keep it in the original packaging or covered in order to minimize the deposition of dust and impurities inside bottles, jars or medicine bottles. Before actual filling, visually inspect the packaging and, if necessary, rinse and disinfect it to ensure maximum hygiene and stability of your cosmetic or artisanal products.