The packaging can be reused if basic hygiene principles are observed. Before each new filling, the bottle and the closure must be thoroughly cleaned and disinfected to minimise the risk of microbial contamination or undesirable reactions with the new contents. For disinfection we recommend using a suitable alcohol-based product, for example IPA 99 % isopropyl alcohol or ethanol 96 % denatured plant-based. After rinsing and disinfection, let the packaging dry completely before refilling it.

For regular cleaning, lukewarm water with a mild soap or a suitable cleaning agent is sufficient, followed by thorough rinsing and optional disinfection with alcohol. The plastic material of this type is not intended to be exposed to high temperatures – contact with hot water, boiling or washing in a dishwasher may cause deformation or deterioration of the closure properties. Therefore, it is not recommended to boil the packaging, sterilise it with steam or clean it in a dishwasher; cleaning should be carried out at moderate temperatures, manually and gently.

The disc-top closure works on the principle of pressing one part of the cap, which opens the dispensing orifice and allows controlled extrusion of the contents. For the first use, we recommend testing a small amount of the product to check the flow rate at different levels of pressure on the bottle walls. Thicker gels or emulsions may require slightly stronger squeezing, whereas more fluid solutions will flow out easily and smoothly. After use, always close the closure again to minimise air access and any unwanted leakage during transport.

If you decide not to reuse the packaging, it is recommended to recycle it according to the recommendations listed in the product parameters. Before disposal, empty the bottle and the closure as much as possible and rinse off product residues to facilitate subsequent processing. Then place the plastic packaging in sorted waste according to local rules (usually in the plastic container) and follow the symbols and information about the material in the parameter table for the product. In this way, you will support more efficient recycling processes and reduce the amount of waste.

When choosing a suitable bottle, vial or jar, we recommend using the advanced filter in the packaging categories. The advanced filter is located at the top of the page after clicking on the relevant category and allows quick sorting of the offer according to several parameters. Specifically, you can filter the neck type, packaging size, colour and material, which significantly facilitates the search for the optimal solution for a specific product or formula. By combining these filters, you will obtain a clear selection of packaging that meets your technical and aesthetic requirements.