The packaging can be used repeatedly if basic hygiene principles are followed and it is handled appropriately. Before each new filling, the bottle and the dispenser must be thoroughly cleaned and then disinfected, ideally using alcohol-based preparations such as isopropyl alcohol or ethanol. For this purpose, you can use the products IPA 99% isopropyl alcohol or Ethanol 96% denatured plant-based. After the disinfectant has completely dried and ventilated off, the bottle can be refilled with a suitable preparation.

The plastic packaging is not intended to be exposed to high temperatures. With long-term or intensive heat exposure, there is a risk of softening or deformation of the material, which may negatively affect the sealing and the function of the dispenser. The packaging is not suitable for washing in a dishwasher or for boiling. For cleaning, we recommend hand-washing with lukewarm water and a mild detergent, thorough rinsing and subsequent disinfection with a suitable alcohol-based preparation before the next filling.

Before filling, make sure that the bottle and all parts of the dispenser are clean, disinfected and completely dry. Fill slowly, ideally using a funnel or dosing syringe, leaving a slight reserve below the thread so that overflow does not occur when the dispenser is attached. Screw the dispenser on evenly without excessive tightening so that the seal is not compromised. We then recommend pressing several times to verify that the pump doses evenly and without excessive air intake.

To make it easier to select packaging, you can use the advanced filter available at the top of the page after clicking on the relevant packaging material category. Using the filter, you can quickly narrow down the offer according to specific parameters such as type and size of the neck, packaging size, colour or material used. By combining these options, you will find a bottle, pharmaceutical bottle or other packaging that will best suit the character of your product and the desired method of application.

If you decide not to use the packaging further, we recommend emptying and cleaning it as well as possible after the contents have been used up. The method of recycling is determined by the type of plastic indicated in the product parameters and the corresponding recycling symbol. Based on this information, place the bottle and the dispenser into the correct segregated waste stream according to the system in your municipality. By following the recommended sorting by material as stated in the product parameters, you will contribute to efficient processing and reuse of raw materials.

The bottle with dispenser is ideal for low- to medium-viscosity preparations where precise and hygienic dosing is desirable – for example facial serums, emulsion fluids, light body milks, hair toners or special treatments for local application. For thicker balms or very thin, highly volatile formulations, we always recommend first performing a trial filling and monitoring the behaviour of the product over time to verify smooth pump operation as well as content stability.