Gloss Black Glass Bottle, White Nasal Spray, 15 ml

A black glossy glass bottle with a capacity of 15 ml and a white nasal spray-type dispenser forms a ready-to-use set for small quantities of liquid cosmetic preparations applied by spraying. The opaque black glass protects the contents from light, making it suitable for hydrolats, tonics and light aqueous solutions with active ingredients that lose their efficacy or change colour in light. The dispenser has a long narrow applicator and releases a small measured dose with each press, allowing targeted application even on small areas.

The set is declared as suitable for contact with cosmetics. The bottle alone also holds a certificate for direct food contact; the dispenser does not, so the set as a whole is intended for cosmetics.

What it is suitable for

• Hydrolats and tonics for travel – the small volume and tight dispenser allow you to carry facial water in a handbag without the risk of leaking.
• Facial and body mists – spraying creates fine droplets that spread evenly on the skin without running.
• Aqueous solutions of active ingredients – sensitive components, such as vitamin C or plant extracts, remain protected from light inside the black glass.
• Scalp tonic – the narrow applicator reaches between the hair directly to the scalp without unnecessarily wetting the lengths.
• Samples and testers – 15 ml is enough to try out a new formula with customers or during development.

Filling and volume

The nominal volume of 15 ml is the quantity the bottle is designed for under normal filling. The total capacity to the brim, stated in the specifications, is the physical volume up to the neck. The difference provides a reserve for the dispenser tube and for the expansion of the contents with temperature changes. The bottle is filled to the nominal volume. When filled to the brim, tightening the dispenser will push some of the contents out through the thread.

The dispenser has a longer tube than the bottle is tall. Before assembling it for the first time, shorten it with an angled cut so that it ends just above the bottom without resting on it. A straight cut flush with the bottom can block suction, and the dispenser will then pump without drawing any liquid.

What is good to know

The dispenser is designed for aqueous and low-viscosity formulas. Thick serums, oils and emulsions of cream consistency cannot be sprayed through the narrow nozzle. The dispenser will clog or the liquid will simply come out in a stream. For solutions with a higher proportion of alcohol or with essential oils, we recommend checking how the plastic parts of the dispenser behave with the specific formulation.

Before the first fill, wash the bottle, disinfect it and allow it to dry completely. Rinse the dispenser with clean water, pump it through and allow it to dry separately from the bottle. A water-based formula with a small volume comes into contact with the tube and dispenser chamber with every use, so allow for reliable preservation.

The bottle is made of glass and can be reused. When changing the filling, wash and disinfect it again. The dispenser is harder to clean, and we recommend using a new one when changing the type of filling. Glass belongs in sorted glass waste; the dispenser is a combination of plastic and steel and is sorted according to the predominant material.

Closures and dispensers with the same neck type stated in the specifications, and further ready-made combinations, are available in the Handymade range. For a custom combination, we recommend verifying the seal and dosing with the specific formulation.

Frequently asked questions